RorysRocketThrow Posted October 22, 2010 Share Posted October 22, 2010 AMD PhenomII X2 3GHz 4GB Ram Radeon X1950XT 256MB Windows 7 64 bit Latest drivers (flushed old drivers last night and re-installed 10.2 Catalyst) installed. Catalyst settings all left at default. Problem I'm getting is the 3D is extremely slow and jerky on high detail, but runs incredibly smoothly on medium and below. I've tried the usual trick of running in full screen, switching to windowed (still as jerky) and then back to full screen again (still as jerky). I'm at work at the moment, so cannot upload any dxdiag data, but is there anything that sticks out from that lot? Regards Link to post Share on other sites More sharing options...
Pompeyboyz Posted October 22, 2010 Share Posted October 22, 2010 On that setup no. It would be mainly due to your graphics card that you will suffer. Try turning off a few details like outside scenes and crowd. You might get it working better but not fully set to high. Link to post Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.